Powerware 9390 Installation & Operation Manual page 32

Installing the UPS System
8. Route the UV trip and Aux wiring harness supplied with the battery cabinet from
9. Connect the wiring to TB2 terminals.
10. Proceed to Step 17.
11. If installing interface wiring from the bottom of the cabinet, proceed to Step 12;
12. Remove the screws securing the bottom internal safety shield panel and remove
NOTE
terminals, conduit must be installed between the UPS and battery cabinets.
13. Remove the UPS cabinet top or bottom conduit landing plate to drill or punch
14. Reinstall the conduit landing plate and install the conduit.
15. Route the UV trip and Aux wiring from the battery cabinet to the UPS.
16. Connect the wiring to the TB2 terminals.
17. If wiring X-Slot connections, proceed to paragraph 3.2.5.3; otherwise, proceed to
18. When all wiring is complete, reinstall the safety shield panels removed in previous
19. Close the control panel door and secure with the retained hardware.
20. Reinstall the door removed in Step 3 or paragraph 3.2.1 and secure with the
21. Close the door and secure the latch.
3-10
the battery cabinet to the UPS cabinet. Refer to Appendix A and to the Powerware
9390 Integrated Battery Cabinet (Models IBC-S and IBC-L) Installation Manual for
wiring access information.
otherwise, proceed to Step 13.
the panel to gain access to the bottom conduit landing plate.
When installing UV trip and Aux battery interface wiring to the UPS interface
conduit holes (see Drawing 164201535-6 on page A-27).
Step 18.
steps. Secure with the retained hardware.
retained hardware.
Powerware 9390 UPS (40–80 kVA) Installation and Operation Manual S 164201535 Rev C
®