Alarm With Location Information; Alarm With Data; Acoustic Location Signal; Automatic Call After Alarm - Aastra DT4x3 DECT Telephones User Manual

User Manual
Aastra DT4x3 DECT Telephones
• A Man-down warning. Cancel? or No- movement warning. Cancel? dialog window is
shown in the display, and a warning tone is also signalling during a period (default 7
seconds) before the alarm is sent.
• To prevent the alarm from being sent and silencing the warning tone, do one of the
following:
- Press any key/button. The alarm is reset.
- Put the handset in a charger. The alarm is temporarily disabled indicated by that the
corresponding alarm icon is hidden. The alarm is enabled when removing it from the
charger.
• If no key/button is pressed during the warning tone, the alarm is sent. Depending on set
parameters, a beep/vibrator/LED signal confirms that the alarm has been sent.
• An acoustic location signal (ALS) may be activated after the alarm has been sent, or a
call may be established to a predefined number. See
page 32, or
• Information about the handset's location may be sent along with the alarm, see

Alarm with Location Information

See also 7.7.10 Alarm Settings
6.3 Alarm with Location Information
Information about the handset's location can be sent along with an alarm. The location can
be added as follows;
• An approximately location given by the closest Base Station (see the handset's
Configuration Manual)
6.3.1

Alarm with Data

The data must manually be defined and stored by the user, see
It is recommended to add a shortcut for quick access to the "Edit alarm data" menu, see
Shortcuts on page 48.
6.4

Acoustic Location Signal

Depending on set parameters, the ramped up ALS is played after an alarm. The signal is
always ramped from the lowest volume to the highest. Press
Depending on the PDM/Device Manager settings, it is possible to make the user enter a
password when turning the ALS off. The password is the same as the phone lock password.
ALS is configurable for Man-down & No-movement alarm, and Push-button alarm. See the
handset's Configuration Manual for more information.
6.5

Automatic Call after Alarm

A handset can be setup to call a predefined number after an alarm has been sent. It is also
possible to dial the number without sending an alarm by pressing a push-button that is not
configured with alarm functionality. Depending on the settings, the call can be established
in the following modes;
• Loudspeaking mode
• Normal mode
5.When Bluetooth is enabled, the loudspeaker audio is lowered due to current limitations in the intrinsically safe handset.
31 October 2013 / Ver. C
6.5 Automatic Call after Alarm
on page 32.
on page 56.
5
, or
6.4 Acoustic Location Signal
on page 32.
Edit Alarm Data
to turn the ALS off.
TD 92789EN
on
6.3
on page 57.
7.6
32