User Manual
Aastra DT4x3 DECT Telephones
2
Select "Transfer to new call"
3
Press "Select".
4
Enter the number of the party the ongoing call is to be transfered to.
5
Press
5.3.11 Conference Call
Prerequisite, a new call has been started during conversation, see
during Conversation
By initiate a conference call, an conversation can be made between several participants
simultaneously.
1
Press "More" during the call.
2
Select "Conference call".
3
Press "Select".
The person initiating the conference call is the conference leader, and the other are
participant members of the conference call.
5.3.12 Send Call Waiting
This feature can be used when you want to announce a person that you are trying to reach
him/her by sending a notification tone to his/her handset. When the person is engaged in a
call, do as follows:
1
Press "More".
2
Select "Call waiting".
3
Press "Select". The other party hears two short beeps to inform that you want to
reach him/her.
When the line is free, the call on hold is redialed automatically. This is a system dependent
feature.
TIP: It is possible to switch between the calls. See
5.3.13 Switch between Calls
Prerequisite, a new call has been started during conversation, see
during Conversation
1
Press "More" during the call.
2
Select "Switch".
3
Press "Select" to switch to the other call. The first call is on hold.
If needed, repeat the steps above to switch between the calls.
5.3.14 Answer Call Waiting
NOTE: Depending on system setup and configuration, this feature might be handled in one
of two different ways:
4.Only visible when the parameters "New call" and "Transfer" are defined in the PDM/Device Manager.
31 October 2013 / Ver. C
4
.
to transfer the call.
on page 27.
on page 27.
5.3.6 Start a New Call
5.3.13 Switch between Calls
5.3.6 Start a New Call
TD 92789EN
on page 28.
28