Restoring To Factory Default Settings - Lorex LHD200 Instruction Manual

Using the Main Menu
To upgrade the system firmware:
1 In your web browser, visit
www.lorextechnology.com
the model number of your DVR (check the
label underneath your DVR for the model
number). Download the free firmware
upgrade if one is available.
2 Extract the firmware into a blank USB
flash drive. The firmware should be in a
folder named dvrupgrade. Ensure that
this is the only folder in the USB drive.
3 Insert the flash drive into one of the USB
ports.
4 Right-click to open the Menu Bar and click
the Main Menu button (
5 Click Advanced.
6 Click Firmware Update.
Firmware Update
7 Follow the on-screen instructions to
update the firmware. Do not remove the
USB flash drive or power off the DVR
during the firmware update. Wait for the
system to reboot.
Restoring to Factory Default
Settings

Restoring to factory default settings

reverts any setting changes you have
made to their original settings. This
does not affect the recordings saved on
the DVR. You can reset a single menu,
or all menus.
50
1
and search for
2
3
).
4
5
6
7
To load system defaults:
Right-click to open the Menu Bar and click
the Main Menu button (
Click Advanced. Then click Load Default.
Select the menus that you wish to restore
to default settings, or click All to restore
the entire system to default settings.
NOTE: It is recommended to leave the
Network menu unchecked when
restoring the system to factory
defaults. If you restore the Network
menu, you will need to redo remote
connectivity setup to access your
DVR over the Internet.
Click Apply.
When the warning window appears, click
OK to restore your settings.
Click OK to return to the menu.
Right-click until you have exited all menus.
The DVR prompts you to restart.
).