Connecting Hd-Sdi Cameras To Your Dvr; Camera Connection Diagram; Connecting And Removing Bnc Cables - Lorex LHD200 Instruction Manual

Basic Setup
2 Adjust the camera stand to ensure that the camera has a satisfactory view of the area you
would like to monitor. Stand configuration depends on the mounting surface you have chosen
(see below for suggested stand configurations).
Table Mount
Camera model not be exactly as shown

Connecting HD-SDI Cameras to your DVR

1 Connect the BNC connector on the camera to the RG59 extension cable.
2 Connect the male power connector on the RG59 extension cable to the female power
connector on the camera.
3 Connect the BNC connector on the other end of the RG59 extension cable to one of the
CAMERA INPUTS ports on the rear panel of the DVR.
NOTE: Make sure to include some slack on the extension cable at both ends when connecting
the camera to the DVR. Strip lines may appear in the image if the cable is too tight.
4 Connect the female power connector on the RG59 extension cable to the power adapter.
5 Plug the camera power adapter to a power outlet.

Camera Connection Diagram

To Camera:
Male power connector

Connecting and Removing BNC Cables

BNC (Bayonet Nut Connector) is a special connector that locks on to the system port and
cannot be accidentally removed.
To connect or remove a BNC connector:
• Push the BNC connector firmly into the BNC port and simultaneously twist the connector
clockwise to tighten.
• To remove a BNC connector from a BNC port, push and simultaneously twist the connector
counter-clockwise to loosen the BNC connector.
10
RG59 Extension cable
BNC
Wall Mount
To Digital Video Recorder:
(8-channel model shown)
Female power connector
Ceiling Mount