Appendix D: Replacing The Hard Drive; Removing The Hard Drive - Lorex LHD200 Instruction Manual

Appendix D: Replacing the Hard Drive

The system comes with a pre-installed SATA hard drive. You can expand the system with a
maximum of two 4TB 3.5" or 2.5" SATA hard drives (for a maximum storage space of 8TB).
NOTE: It is recommended to use surveillance or security-certified hard drives, which are
designed to be reliable over long periods of time while recording 24/7. Security-certified
hard drives are available at

Removing the Hard Drive

Make sure that the power cable has been disconnected before changing the
hard drive.
1 Remove the screws from each side panel (x2) and rear panel (x4) of the cover.
2 Gently slide the cover away from the rear panel and lift off. Be careful of sharp edges.
3 Disconnect the power and data cables.
4 Next remove the hard drive from the housing:
• If your system has a 3.5" hard drive, remove the 4 screws holding the hard drive bracket and
remove the bracket from the DVR. Remove the 4 screws securing the hard drive to the bracket
www.lorextechnology.com
Appendix D: Replacing the Hard Drive
107