Configuring Email Notification Settings - Lorex LHD200 Instruction Manual

2 Configure the Substream settings:
• Channel: Select the channel you wish to apply the settings to.
• FPS (Framerate): Select the desired recording frame rate. Note that higher frame rates
require greater bandwidth consumption during remote viewing.
• Bitrate: Select the desired video bitrate.
• Audio: Select Enable or Disable to enable or disable the system from streaming audio when
viewing the system remotely.
3 Click Save to apply your settings.

Configuring Email Notification Settings

To configure email notification settings:
1 Click the Remote Setting tab, and click Network> Email.
2 In the Email drop-down menu, select Default to use the default Lorex email server
(recommended) or select Custom to use your own custom SMTP email server.
If you want to use Lorex's email server (recommended):
1 In the Sender Email field, enter the email address of the sender. This can be any email
address of your choice.
2 In the Receiver Email field, enter the email address you want the DVR to send alarm
notifications to.
3 In the Interval drop-down menu, enter the duration the DVR must wait before sending out a
new notification. 

For example, if you select a 3 minute interval, the DVR will send out email notifications every
3 minutes until the DVR stops detecting motion / alarm. The DVR will only send out
notifications when it detects motion/alarm triggers.
4 Click Save to save your settings.
If you select "Enable", and want to use your own email server:
1 Configure the following:
• SSL: Select Enable or Disable to enable/disable Secure Socket Layer protocol.
Using the PC/Mac Client Software
69