Remote Access; Configuring Fpi Password; Configuring Rmi Password - Tandberg Data StorageLibrary T40+ Series Installation And User Manual

From the RMI, select Setup > Network
From the FPI, select Menu > Setup > Network

Remote Access

If you choose to complete the Setup Wizard remotely, the wizard on the front panel interface (FPI)
automatically displays the Network settings you need in order to access the remote management
interface (RMI).
The network settings are also viewable from the front panel Menu > Reports > Network screen.
The screen provides the information necessary to access the remote management interface.
The screen lists the IP address of the library. Use this IP address to access the remote management
interface using a web browser. When typing the IP address into a web browser, make sure you
precede it with "http://" (for example, http://123.123.123.123).
The legal values are enable and disable.

Configuring FPI Password

There are two user access levels in the library: Operator and Administrator. The FPI has two levels of
password corresponding to the two access levels.
The Operator has access to all of the features in the Reports and Operations sub-menus. These
features allow the Operator to check statistics and issue basic tape management functions. The
Operator does not have access to any features that change settings in the library or run diagnostics.
The Administrator has access to all features.
If a password is enabled, it is enabled for both the Operator and the Administrator. If the password is
disabled, it is disabled for both the Operator and the Administrator. Enabling the password prompts
the operator to set passwords for both the Operator and Administrator. The default for the library is
password disabled.
The FPI Operator and Administrator passwords are configured from the FPI or RMI.
The FPI password is limited to a maximum of 4 numeric characters. The password text is masked
when being entered through the FPI.
If the FPI passwords are enabled, the FPI interface requires that the Administrator password is
entered before it allows access to the Change Passwords dialog.
If you set a password, make sure you do not forget it. If you do, it can only be
Caution
reset with assistance from Tandberg technical support. For contact information,
please refer to
The FPI password is configured with the Setup Wizard. After the initial setup of your library you can
later access the FPI Password configuration screens directly:
From the RMI, select Setup > Library
From the FPI, select Menu > Setup > Library

Configuring RMI Password

When you log into the RMI, a specific level of security is always assigned. It is not possible to access
the library remotely without entering a password. Use the default administrator account if you want to
log in as administrator and the default operator account if you want to log in as operator. The default
administrator user name is "Administrator" and its default password field is blank. The default operator
user name is "Operator" and its default password field is blank.
StorageLibrary T40+ Series Installation and User Guide
Getting More Information or Help.
59