Table of Contents
Advertisement
The transport locking screws will be detected when the StorageLibrary is powered on. To remove the
screws follow the instructions below:
1. Connect the power cord to the power connector on the back of the library.
2. Turn on the power switch on the back of the library.
3. The library detects that the transport locking screws are present. Follow the instructions on the
front panel display to remove the magazines in order to get access to the screws. Remove the
screws and re-insert the magazines.
The library will now continue its power-on sequence.
Keep the transport locking screws in a safe place. You will need them to
Note
lock the robotics if you need to return your StorageLibrary for service or
repair.
The warranty does not cover damage to the library if it is transported
Caution
without the transport locking screws properly installed. See
the Transport Locking Screws
transport locking screws.
Mounting the Rack mount Ears
To mount the rack mount ears, the four magazines must be removed. To remove the magazines,
follow the instructions below:
1. Connect the power cord to the power connector (for power supply 1) at the back of the library.
2. Turn on the power switch (for power supply 1) at the back of the library.
3. Wait until the library completes its power-on sequence.
4. Use the front panel interface to remove the magazines (Menu > Operations > Eject
Magazine).
5. Physically remove the magazines from the library, see
If your library supports 24 magazine slots only, you need to use the emergency eject tool to remove
the two upper magazines. The emergency eject tool is located at the back of the library. See
Manual/Emergency Release of
insert the magazines into the library.
Figure 22. Mounting the Rack Mount Ears
34
for instructions on how to re-install the
Magazines. Mount the ears to the chassis of the library. Gently re-
Magazine
Handling.
Re-inserting
Hardware Installation
Advertisement
Table of Contents
Troubleshooting
