Using The Setup Wizard; Setup Wizard Tasks - Tandberg Data StorageLibrary T40+ Series Installation And User Manual

You cannot delete the default Administrator account. You can, however, change
Note
the password.

Using the Setup Wizard

The Setup Wizard simplifies the process of configuring the library. When you first power on the library,
the front panel interface (FPI) displays the Setup Wizard. As you work through the Setup Wizard
screens, follow the on-screen instructions.
The recommended procedure for using the Setup Wizard for the initial configuration is as follows:
1. Turn on the library and go to the Setup Wizard on the FPI. Be sure to configure network settings.
2. When the Setup Wizard screen text prompts you to choose Local or Remote, you must choose
whether to complete the wizard either locally on the FPI, or remotely on the RMI.
3. If you choose to complete the wizard remotely, you must log in to the RMI. Use the default
Administrator account. The default User Name is Administrator, and the default password field is
blank.
4. Complete the Setup Wizard.
You may choose to use the default settings that the Setup Wizard suggests, but you must confirm
the proposed settings and complete the Setup Wizard before you can begin to use the library.
If you choose to complete the Setup Wizard remotely, the FPI wizard automatically displays the
network settings you need to access the RMI.
If you run the Setup Wizard from the FPI and you do not complete all the Setup Wizard screens,
the library will save whatever modifications (if any) you have made. However if you run the Setup
Wizard from the RMI, you need to confirm that you want to save the setup.
You do not need to log into the library from the FPI when the Setup Wizard appears on the front
panel, the first time the library is powered on.
When you power-on your library for the first time, you can only configure network settings on the
FPI, and you cannot log into the library from the RMI until you have configured network settings.
You can always return to the Setup Wizard whenever you are logged in as Administrator to either
the FPI or RMI.
The setup wizard may need to reboot your library one or more times during setup
Note

Setup Wizard Tasks

The Setup Wizard contains all configuration options. When you first power on the library you must
complete the Setup Wizard. When you later want to re-configure the library you can choose to either
use the Setup Wizard or the individual configuration options found in the Setup menus.
This section includes an overview of the Setup Wizard configurations. The configurations are
described in detail in the following chapters.
You may not see all the choices presented below when running the Setup Wizard
Note
using the FPI. It routes you past choices that have become irrelevant because of
previous selections.
Example: If you select DHCP mode on the RMI, the Static IP address, netmask
and default gateway are irrelevant.
Welcome - Welcomes you to the Setup Wizard.
50 Configuring the Library