Inch Adapter; Label Taken Sensor; Interface Boards - Intermec EasyCoder PX4i User Manual

3-inch Adapter

Label Taken Sensor

Interface Boards

EasyCoder PX4i Bar Code Label Printer User's Guide (IPL Version)
The 3 in/76 mm adapter is included in the package and makes it
possible to use media rolls with 3 in/76 mm inner diameter
cardboard cores.
The adapter is pressed onto the media supply hub and held in
place by a screw. When fitting the adapters, make sure that the
screw hits a rounded plastic surface, not a metal leaf spring.
Illustrations of how to load the media using the adapter can be
found in "Loading Media" on page
The Label Taken Sensor (LTS) is a photoelectric sensor fitted to
the center section inside the front door. It allows the printer's
firmware to detect if the latest printed label, ticket, tag etc. has
been removed before printing another copy.
The label taken sensor is usually factory-fitted, but is also
available as a kit for installation by an authorized service
technician. It cannot be fitted in combination with a paper
cutter.
A number of interface boards are available for use with the
EasyCoder PX4i printer. The interface boards are either factory-
fitted or can easily be fitted by an authorized service technician.
The EasyCoder PX4i printer can accommodate one EasyLAN
interface board plus one other interface board.
EasyLAN boards:
• EasyLAN Ethernet interface
• EasyLAN Wireless interface
Other communication boards:
• Parallel Interface Board (IEEE 1284)
Chapter 8 — Options
17.
77