Intermec EasyCoder PX4i User Manual page 97

Chapter 9 — Troubleshooting
Display Messages and LED Indications
Error/Event
Power supply over
temperature
Printhead hot
Note 1: This is only applicable for printers equipped with an EasyLAN interface.
Note 2: A printer that is equipped with an EasyLAN interface, but is not connected to a
network, will have a blinking RTW. To avoid this, the user can set "IPSELECTION" to
"MANUAL" and "IP ADDRESS" to "0.0.0.0". This will indicate that the user does not regard
the lack of network connection as an error.
Note 3: No trap can be sent when this error/event occurs.
Note 4: This error indicates that the printer has not received an IP address. It is only applicable
for printers with IP SELECTION set to DHCP and/or BOOTP.
Note 5: At most, but not all, printer crashes, the console is reset. This will make the RTW go
off.
Note 6: If the printhead temperature raises above 100°C (212°F), an error occurs and
the printing will be paused until the printhead has cooled off. Meanwhile, the printer is
able to receive commands and data until the buffer is filled. The printing is
automatically resumed when the printhead temperature has reached 85°C (185°F).
82
Ready-To-Work Error Message
Off PSU OVER
TEMP
Off PRINTHEAD
HOT
EasyCoder PX4i Bar Code Label Printer User's Guide (IPL Version)
Comment
See note 6 on next page.