Fan-Fold Guides; 3-Inch Adapter; Label Taken Sensor - Intermec EasyCoder PX6i User Manual

Chapter 9 — Options
Should you inadvertently have cut through self-adhesive labels, you will
have to clean the cutting parts. Tilt down the cutter and clean using a
piece of tissue moistened with isopropyl alcohol.
The cutting edge will rotate when the power is switched on
and when the printer is re-booted. Always keep the cutter
in closed position during operation. Switch off the power
or disconnect the cutter before cleaning. Keep your fi ngers
away from cutting parts!

Fan-Fold Guides

The fan fold guides provide a more exact guiding of the media, when the
supply is placed outside the media compartment, for example a stack of
fan-folded tickets. The guides come as an operator-installable kit with
installation instructions. The guides can be fi tted in the upper or lower
slot in the rear plate. Instructions for loading the media is included in the
section "External Supply" in Chapter 4, "Media Load."

3-inch Adapter

Two 3-inch/76 mm adapters are included in the package and makes it
possible to use media rolls with 3 inch/76 mm inner diameter cardboard
cores.
The adapter is pressed onto the media supply hub and is held in place
by a screw. When fi tting the adapters, make sure that the screw hits a
rounded plastic surface, not a metal leaf spring. Illustrations of how to
load the media using the adapter can be found in Chapter 4, "Media
Load."

Label Taken Sensor

The Label Taken Sensor (LTS) is a photoelectric sensor fi tted to the
center section inside the front door. It allows the printer's fi rmware to
detect if the latest printed label, ticket, tag etc. has been removed before
printing another copy.
The label taken sensor is usually factory-fi tted, but is also available as a
kit for installation by an authorized service technician. It cannot be fi tted
in combination with a paper cutter.
94 EasyCoder PX6i User's Guide (Fingerprint version)