Intermec EasyCoder PX4i User Manual page 121

Chapter 11 — Adjustments
106
Return to the centered cursor position by pressing Down.
If the cursor behaves as described above, the LSS is working and
is properly aligned with the gaps, slots, or black marks.
If the cursor does not react to a gap, slot, or black mark, check
the following:
• Is the LSS laterally aligned with the slots or black marks?
• Are both the upper and lower part of the LSS aligned with
each other?
• Is the transfer ribbon properly loaded so it does not
interfere with the LSS (See
page 46)?
• Are the label stop sensors free from dust and are the guides
free from stuck labels or other objects that may interfere
with the light that goes from one part of the LSS to the
other? If necessary, clean the sensors.
• Does the media have some kind of preprint that can
disturb the detection?
• Is there too little difference between the black marks and
the surrounding areas?
• Does the liner have too little transparency?
• Does the LSS work with another type of media?
To change the Media Type setup, lift and lower the
printhead and then press Feed/Pause.
EasyCoder PX4i Bar Code Label Printer User's Guide (IPL Version)
"Loading Ribbon" on