Intermec EasyCoder PX4i User Manual page 96

Display Messages and LED Indications
Error/Event
Operational
Out of paper
Out of transfer ribbon Blink
Transfer ribbon is
installed
Head lifted
Cutter error1
Cutter error2
Cutter error3
Lss too high
Lss too low
Testfeed not done
Press feed not done
Pause mode entered
Setup mode entered
IP link error
IP configuration error Blink
Printhead not found
Rebooted
Initializing
Printer crash
Printer turned off
Maintenance
EasyCoder PX4i Bar Code Label Printer User's Guide (IPL Version)
.
Ready-To-Work Error Message
On
Blink PAPER OUT
RIBBON OUT
Blink RIBBON FITTED
Blink PRINTHEAD UP
Blink OPEN&SHUT
CUTTER
Blink OPEN&SHUT
CUTTER
Blink OPEN&SHUT
CUTTER
Blink PAPER FAULT
Blink PAPER FAULT
Blink PAPER FAULT
Blink PRESS FEED
Blink PAUSED
Blink
Blink
Off NO PRINTHEAD
Off
Off
Off
Off
Off
Chapter 9 — Troubleshooting
Comment
Not an error.
Including interactive
setup.
See notes 1, 2, and 3 on
next page.
See notes 1, 3, and 4 on
next page.
Appears at startup until
operational.
See notes 3 and 5 on next
page.
Appears when upgrading.
81