Comtech EF Data Vipersat CDM-570 User Manual page 36

I n i t i a l C o n f i gu r a t i o n
7.
8.
9.
This completes the initial configuration of a CDM-570/570L from the factory
default settings to a functioning, Vipersat-enabled unit. Additional configura-
tion parameters must be set depending on the network requirements for a
specific application.
Refer to Chapter 3, "Using the Command Line Interface," for additional details
on configuring the target Vipersat CDM-570/570L.
2-12
Enter I at the command prompt to set the Managing IP Address.
The Managing IP Address is the IP address of the VMS server.
Enter H to go to the Home State Configuration menu screen, then enter
W to set the current configuration as the Home State.
Save the settings to flash by entering S at the command prompt.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e