Delete; View; Figure 3-50 Tos Delete Prompt - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o nf i g u r a t i o n
• Enter the TOS ID - Enter an integer value in the range of 1 to 63.
• Enter the Switch Type - Enter an integer value in the range of 64 to 254
• Enter the TOS SCPC Switch Data Rate - Enter the desired data rate for
• Enter the TOS SCPC Timeout - This timer monitors the defined packet
After entering the timeout value, pressing the Enter key will update the TOS
Switching Control menu with the changes.

Delete

Enter D at the command prompt in figure 3-48 to Delete a ToS entry, as shown
in figure 3-50.
Note: The value shown in the TOS Value column is the TOS ID associated
NOTE

View

Entering a V at the command prompt will display the Internal TOS Table for
active entries as shown in figure 3-51.
Note that, due to binary conversion, the ID value is a multiple of 4 and the
Timout value is a multiple of 2.
3-40
Entering a value of 0 will result in no switch.
at the prompt to inform the VMS what switching policy to use. Entering a
value of 0 will result in no switch.
this service type. Valid entries are from 0 to 10,000 Kbps. This setting will
override the VMS set policy value.
flow. Once data stops for the duration of the timer setting, the link state
will be restored to the home state condition. Valid entries are from 1 to 60
seconds.
with the ToS entry to be deleted.
Figure 3-50
ToS Delete prompt
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e