Set Current Configuration As Home State - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o nf i g u r a t i o n
Enter H at the command prompt in the Vipersat Configuration screen to
display the Home State Configuration screen shown in figure 3-69.
Figure 3-69
Home State Configuration screen
Note that each of these Transmit and Receive parameters are the same as found
in the Tx Configuration and the Rx Configuration screens that are in the
Satellite Modem Configuration menu.

Set Current Configuration as Home State

This command sets the CDM-570/570L's current configuration as its Home
State settings. Assuming the modem has been properly configured using the
Satellite Modem Configuration menu (Tx and Rx parameters) and the
Feature Configuration menu (Vipersat STDMA setting), these parameter
values will be copied into the Home State configuration. Rather than entering
each of these values individually, this command can be used as a shortcut for
establishing the Home State settings.
Enter W at the command prompt in the Home State Configuration screen to
execute this command. Once saved, the modem will be configured with the
Home State settings at boot time and when manually reset with the Force
Modem to Home State command.
Tip: This command is useful when a CDM-570/570L's initial set up is
completed and the unit is functioning as desired in a network.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
3-54