Upgrade Base Modem To V1.5.1 (Cdm-570 Only; Upgrade Image 1 On Base Modem To V1.4.5; Figure D-13 Configuration File Text; Figure D-14 Browse For Firmware File - Comtech EF Data Vipersat CDM-570 User Manual

F i r m w a r e U p g r a d e
2. Save the configuration file. Open it using WordPad. Insure that the lines
3. If this text is not displayed, Save to flash again, get the configuration and

Upgrade Base Modem to v1.5.1 (CDM-570 Only)

For units with v1.3.3 firmware, the Base Modem upgrades have to be done in 2
steps. This is necessary because the memory map changed with the v1.4.x firm-
ware, and v1.3.3 is not capable of writing directly to v1.5.x firmware.

Upgrade Image 1 on Base Modem to v1.4.5

Select Base Modem under Mode Selection, then click Browse. Two files
1.
D-12
shown in figure D-13 are in the configuration near the bottom of the file.
check for them in the configuration file once more. Note that the contents of
the text lines will differ based on the actual configuration and modem type.
named FW10805 will appear. Select the file name that ends with "P"; this is
the v1.4.5 firmware file.
Figure D-14
Figure D-13
Configuration File Text
Browse for Firmware File
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e