Delete Remote; Enable/Disable Remote - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-24 Global SCPC Data Rate prompt
Similarly, the Global Switch Type command can be used to set the switch type
for all or a majority of the Remotes. Enter H at the command prompt.
Figure 3-25 Global Switch Type prompt

Delete Remote

Entering D at the command prompt shown in figure 3-17 brings up the Delete
Remote dialog shown in figure 3-26.
Figure 3-26
Delete Remote prompt
Enter the number of the Remote CDM-570/570L at the command prompt to
delete it from the STDMA group for this Hub burst controller.

Enable/Disable Remote

Enter E at the command prompt in figure 3-17 to display the dialog shown in
figure 3-27. The Remotes in the STDMA group are displayed, indicating
whether each is currently Enabled (E) or Disabled.
Figure 3-27
Enable/Disable Remote prompt
Enter the number of the Remote at the command prompt to toggle the Remote
from its current Enable/Disable configuration.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
3-22