View Remote(S); Remove Timeout - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o n f i g u r a t io n
In the example screen shown above, Remotes 1 and 2 are Enabled and Remotes
3 and 4 are Disabled.

View Remote(s)

Entering V at the command prompt shown in figure 3-17 will display the listing
of Remote(s) that belong to the STDMA group for this Hub burst controller, and
their status, as shown in figure 3-28.
Figure 3-28 View Remote(s) screen
The display is for information only and pressing any key will return the screen
to the menu shown in figure 3-17.

Remove Timeout

Entering R at the command prompt shown in figure 3-17 will display the
Remove Timeout dialog shown in figure 3-29. Note that this menu item shows
the current setting (in seconds) for this parameter.
Figure 3-29
Remove Timeout prompt
The value entered at the command prompt defines the amount of time (in
seconds) with no communication from a Remote to the Hub before that Remote
is removed from the Burstmap. If communications are lost for this period of
time, the Remote is removed from the STDMA group, and the bandwidth
resources it had been allocated are then made available for use by the other
remotes remaining in the group.
This feature is useful, for example, in an SNG application where a mobile
Remote has finished its assignment and has shut down.
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-23