Transmit Modulation Type; Transmit Power Level; Transmit Enable; Receive Frequency - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o n f i g u r a t io n

Transmit Modulation Type

Entering E at the command prompt to use the dialog shown in figure 3-75 to set
the Transmit Modulation Type for the target CDM-570/570L's Home State.
Figure 3-75 Transmit Modulation Type prompt

Transmit Power Level

Enter F at the command prompt to use the dialog shown in Figure 3-76 to set
the Transmit Power Level for the target CDM-570/570L's Home State.
Figure 3-76 Transmit Power Level prompt

Transmit Enable

The modem transmitter can be Enabled or Disabled with this command. Enter G
at the command prompt to toggle the Transmit Enable for the target
CDM-570/570L's Home State between On and Off.

Receive Frequency

Enter M at the command prompt to use the dialog shown in Figure 3-77 to set
the Receive Frequency for the target CDM-570/570L's Home State.
C h ap t e r U s i n g t h e C o m m a n d L in e I n t e r f a c e ( C L I )
3 - 3-57