Installing An Accessible 5.25-Inch Drive - Fujitsu PRIMERGY TX200 S6 Options Manual

Accessible drives and LSD/LSP
7.2

Installing an accessible 5.25-inch drive

Magnetic tape drives and DVD drives are available as accessible 5.25-inch
drives. These drives can be installed in the free 5.25-inch bays.
Ê Open the server as described in the
Ê Remove the front cover or rack front cover as described in the
"Removing the front cover" on page 29
front cover" on page
I
New 5.25-inch drives are supplied without EasyClick rails. Before
installing a new 5.25-inch drive you must therefore remove the EasyClick
rails from the dummy cover and mount the EasyClick rails on the new
5.25-inch drive.
I
If you install a magnetic tape drive with double height (3.2-inch), two
dummy covers of the free 5.25-inch bays must be removed.
Figure 22: Removing the dummy cover
Ê Press the metal tongues on the sides of the EasyClick rails inward (1) until
the locking mechanism disengages.
Ê Pull the dummy cover out of the bay frontward (2).
54
chapter "Preparation" on page
32.
Options Guide
or in the section "Removing the rack
27.
section
TX200 S6