Conversion To Hot-Plug Ps And Redundant System Fans - Fujitsu PRIMERGY TX200 S6 Options Manual

10 Conversion to hot-plug PS and
redundant system fans
V
CAUTION!
Follow the safety instructions in the
page 19.
Ê Open the server as described in the
V
CAUTION!
System fans 1 and 2 are replaced by the redundant system fans 1&3 and
2&4.
Ê Remove system fan 2 as described in the
(or 2&4)" on page
Ê Remove system fan 1 as described in the
(or 1&3)" on page
Ê Disconnect all power cables from the system board and the drives (see the
cabling plans in the Appendix).
Ê Remove all power cables from the cable clamps.
TX200 S6
34.
35.
Options Guide
chapter "Safety instructions" on
chapter "Preparation" on page
section "Removing system fan 2
section "Removing system fan 1
27.
93