Fujitsu PRIMERGY TX200 S6 Options Manual page 92

Further options
Figure 73: Installing the serial connector
Ê Insert the long slot cover with the serial connector in slot 7 (1) as described
in the section "Installing expansion cards" on page
Ê Route the cable in the bracket on the right (2) as shown in the photo.
Ê Connect the free end of the cable to the COM2 connector on the system
board (3).
Ê Reinstall system fan 2 (or 2&4) as described in the
fan 2 (or 2&4)" on page
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
92
108.
107.
Options Guide
73.
section "Installing system
TX200 S6