Fujitsu PRIMERGY TX200 S6 Options Manual page 49

Ê Remove the residual thermal paste from the underside of the heat sink.
Ê Clean the underside of the heat sink using a lint-free cloth.
Ê Release the spring clip by pressing it sideways and pull it upward as far as
it will go.
Ê Open the processor holder.
Ê Carefully lift the installed processor out of the socket.
Ê Hold the new processor between your thumb and index finger and align it at
the socket coding.
Ê Place the new processor in the socket with great care.
V
CAUTION!
Do not bend the spring contacts of the processor socket. Never touch
the underside of the processor. Even light contaminants, such as oil
from human skin, can destroy the processor or impair its functionality.
Ê Close the processor holder.
Ê Lock the processor in the socket by returning the spring clip to its original
position.
Ê Apply a small amount of thermal paste to the upper side of the new
processor.
Ê Ensure a thin and even distribution of the thermal paste.
Ê Mount the heat sink on the processor so that the side with the visible copper
heat pipes is pointing in the direction of the memory slots.
Ê Fold down the two heat sink retaining clips at the same time and lock the
heat sink by returning the heat sink retaining clips to their original position.
Ê Reinstall system fan 2 (or 2&4) as described in the
fan 2 (or 2&4)" on page
Ê Close the server, connect it to the power outlet, and switch it on as described
in the chapter "Completion" on page
TX200 S6
108.
107.
Options Guide
Processors
section "Installing system
49