Fujitsu PRIMERGY TX200 S6 Options Manual page 14

Introduction
Additional expansion cards in the PCI slots
The system board offers six PCI slots:
– 5 x PCIe slots, all mechanical x8:
– 2x PCIe x8 slots (Gen2), one slot is open on the right side to allow a x16
graphics card to be inserted
– 2x PCIe x4 slots (Gen2)
– 1x PCIe x4 slot (Gen1)
– 1 x PCI slot (32 bit / 33 MHz)
Trusted Platform Module (TPM)
The server can be equipped with a TPM (Trusted Platform Module). This
module enables programs from third party manufacturers to store key
information.
USB Flash Module (UFM)
The server can be equipped with a USB Flash Module (UFM). This module can
be used as optional memory for software (e.g. VMware) or as a software dongle.
Second serial connector
As an option, a second serial connector can be provided.
Conversion of standard power supply to hot-plug power supply and
standard system fans to redundant system fans
The standard power supply can be replaced by a hot-plug power supply. The
hot-plug power supply consists of two power supply modules.
If one power supply module fails, the other power supply module guarantees the
unrestricted operation and the defective power supply module can be replaced
while the system is operating (hot-plug).
The standard system fans can be upgraded to redundant system fans. If the
redundant system fans are installed, the fans are operating in a redundant
configuration. A defective system fan can be replaced during the next service.
Conversion from a floorstand model to a rack model
The floorstand model can be optionally converted to allow the server to be
installed into any typical rack systems.
14 Options Guide
TX200 S6