Accessible Drives; Installing An Accessible 5.25-Inch Drive - Fujitsu PRIMERGY TX300 S3 Options Manual

8

Accessible drives

V
CAUTION!
Observe the safety instructions in the
page 11ff.
Three free 5.25-inch bays are available for accessible drives.
In the third 5.25-inch bay a DVD-ROM drive or a multibay (FDD-DVD-LocalView
box) can be installed. The multibay can be equipped with a slimline floppy disk
drive, a slimline CD/DVD drive and a LocalView module.
In the second and the third 5.25-inch bay a SAS/SATA HDD extension box can
be installed. This SAS/SATA HDD extension box can be equipped with a slimline
floppy disk drive (or a LocalView module), a slimline CD/DVD drive and two
SAS/SATA hard disks.
8.1

Installing an accessible 5.25-inch drive

The 5.25-inch drives available are magnetic tape drives and DVD-ROM burners.
These drives can be installed in the free 5.25-inch bays.
Ê Open the server and remove the front cover or rack front cover as described
in the chapter "Preparation" on page
I
New 5.25-inch drives are supplied without EasyClick rails. Before
installing a new 5.25-inch drive you must therefore remove the EasyClick
rails from the dummy cover and mount the EasyClick rails on the new
5.25-inch drive.
I
If you install a magnetic tape drive with double height (3.2-inch), two
dummy covers of the free 5.25-inch bays must be removed.
TX300 S3
chapter "Safety notes" on
17ff.
Options Guide 47