System Basic Operation Commands; Enable - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.4 System Basic Operation Commands

This section explains the basic commands of the device CLI (Command Line Interface).

5.4.1 enable

Function
Switches from the operator exec mode to the administrator exec mode.
When a password is set for the "enable" command, a password is required. When there is an error in entering the password,
re-entering the password will be allowed up to three times. Additionally, after successful authentication of the password, for a
given login session, the user will not be prompted for the password until they exit the administrator exec mode and re-enter the
mode.
Prompt
xg>
Command syntax
enable
Command type
Operation management commands
Example
Switch from the operator exec mode to the administrator exec mode using the "enable" command.
The prompt character will change to "xg#."
xg> enable
xg#
When a password is set for the "enable" command, enter the password.
When password authentication is successful, control switches to the administrator exec mode, and the prompt character will
change to "xg#."
xg> enable
Password:
xg#
←Enter the password to "enable."
(The entered password is not displayed.)
73/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009