Snmp (Snmp Control: 8500-8599) - Fujitsu XG2000 Series User Manual

Xg2000 series compact, 20-port 10 gigabit ethernet layer 2 switch
Hide thumbs Also See for XG2000 Series:
Table of Contents

Advertisement

XG2000 series User's Guide
A.2.11

snmp (SNMP Control: 8500-8599)

Message ID
Severity
S8500
INFO
S8501
INFO
S8502
INFO
P8510
WARNING
SNMP authentication failure.
Explanation
The device denied an SNMP request from a SNMP manager.
Solution
Review the SNMP permission from the SNMP manager using the "snmp access" command.
RMON alarm by rising-threshold.
index:%1$ OID:%2$ sample:%3$ value:%4$ rising-threshold:%5$
Explanation
The current sampled value was greater than the upper threshold defined by the "rmon alarm" command. A
SNMP trap for the corresponding RMON event was generated.
[[Inserted string]]%1$: RMON alarm index
[[Inserted string]]%2$: OID of MIB object to be monitored
[[Inserted string]]%3$: Method of determining threshold
1: An absolute value is used when determining threshold (absolute)
2: The difference between the previous and current values is used when determining threshold (delta)
[[Inserted string]]%4$: Value of MIB object to be monitored
[[Inserted string]]%5$: Upper threshold of MIB object to be monitored
RMON alarm by falling-threshold.
index:%1$ OID:%2$ sample:%3$ value:%4$ falling-threshold:%5$
Explanation
The current sampled value was less than the lower threshold defined by the "rmon alarm" command, and a
SNMP trap for the corresponding RMON event was generated.
[[Inserted string]]%1$: RMON alarm index
[[Inserted string]]%2$: OID of MIB object to be monitored
[[Inserted string]]%3$: Method of determining threshold
1: An absolute value is used when determining threshold (absolute)
2: The difference between the previous and current values is used when determining threshold (delta)
[[Inserted string]]%4$: Value of MIB object to be monitored
[[Inserted string]]%5$: Lower threshold of MIB object to be monitored
Cannot find host %1$.
Explanation
Failed to find an IP address for the host name specified with the "snmp-server trap" command.
[[Inserted string]]%1$: Host name specified with the "snmp-server trap" command
Solution
Review the host name defined. Check that DNS was configured.
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Message/Explanation/Solution
298/315

Advertisement

Table of Contents
loading

Table of Contents