Table of Contents
Advertisement
XG2000 series User's Guide
6.4.2 Procedure for Extracting Maintenance Information when an
endless System Loop Occurred
This section describes the procedures for extracting maintenance information when an endless system loop occurs.
A system loop occurred.
If a CLI command entry is not accepted for an extended period of time, a system loop may
exist.
Press the "dump" switch on the device's front panel.
The maintenance information is automatically saved when the "dump" switch is pressed, and
then the system restarts.
***Reporting system logs on dump outputs/Reporting traps
After the system retorts, a system log is issued to indicate that a forced system dump was
generated. Configuring an SNMP trap in advance causes a trap indicating the occurrence of
a system failure to be reported to a system administrator.*** Use previously edited bullet***
Viewing maintenance information history
Using the
xg# show maintenance
Maintenance Information
==================================================
NO Type
--- -------------------------- -------------------
==================================================
The maintenance information that was saved by the "dump" switch is represented by "system
dump(Dump switch)" under the "Type" column.
Extracting maintenance information
Using the
information to a remote server.
Contact the sales representative.
6.4.3 Procedure for Extracting Maintenance Information when a
Malfunction Occurs
This section describes the procedures for extracting maintenance information when a malfunction occurs.
A malfunction occurred.
When a function configured for the device fails to operate properly, the maintenance
information can be extracted.
Using the
Viewing maintenance information history
Using the
xg# show maintenance
Maintenance Information
==================================================
NO Type
--- -------------------------- -------------------
==================================================
The maintenance information that was saved by the
by "system state" under the "Type" column.
Extracting maintenance information
Using the
information to a remote server.
Contact the sales representative.
"show
maintenance" command, check that the maintenance information was saved.
1 system dump(Dump switch)
"tftp
put-maintenance" or
"save
maintenance" command, save the maintenance information.
"show
maintenance" command, check that the maintenance information was saved.
1 system state
"tftp
put-maintenance" or
All Rights Reserved, Copyright (C) PFU LIMITED 2009
2007/01/22-15:55:20
Occurred Time
2007/01/22-18:21:23
"scp
put-maintenance" command, forward the maintenance
2007/01/22-15:55:20
Occurred Time
2007/01/22-20:58:14
"save
maintenance" command is represented
"scp
put-maintenance" command, forward the maintenance
275/315
Advertisement
Table of Contents
