XG2000 series User's Guide
5.13 QoS Setup Commands
This section explains the Quality of Service (QoS) configuration commands.
5.13.1 show qos
Function
Displays the current Quality of Service (QoS) status.
Prompt
xg> or xg#
Command syntax
show qos [ qos-map ]
Parameter
qos-map
Displays the QoS priority mapping information (that is, the output queue information for
each priority).
There are four levels of output queues (levels 0 to 3). A higher value has the higher output
priority.
If this parameter is omitted, all QoS information is displayed.
Command type
Operation management command
Output form
xg# show qos
QoS Information
===============================================================================
Priority Output Queue Mapping
-----------------------------------------
Qos Priority:
----------------- -- -- -- -- -- -- -- --
Output Priority:
-----------------------------------------
==============================================================================
QoS Priority Mapping Information
Qos Priority
Displays the QoS priority (0 to 7).
Output Priority
Displays the output queue level for each priority (0 to 3).
Example
Display the QoS status:
xg# show qos
0 1 2 3 4 5 6 7
1 0 0 1 2 2 3 3
180/315
All Rights Reserved, Copyright (C) PFU LIMITED 2009
2007/01/22-12:12:15