Table of Contents
Advertisement
XG2000 series User's Guide
3.1.2 Configure Management LAN Interface
The management LAN interface is initially enabled.
(IP address: 192.168.0.2, subnet address: 255.255.255.0)
To use the following functions, configure the management LAN interface.
−
−
−
−
−
−
−
−
To configure the management LAN interface, carry out the following procedure.
xg login: admin
Password: ********
xg> enable
xg# configure terminal
xg(config)# management-lan ip A.B.C.D/M
[ default-gw A.B.C.D]
xg(config)# management-lan dns-server A.B.C.D
xg(config)# management-lan domain DOMAIN-NAME
xg(config)# remote-host A.B.C.D HOST-NAME
xg(config)# exit
3.1.3 Telnet Connection via the Management LAN Interface (Optional)
The "Telnet server function" via the management LAN interface is initially disabled.
To change the monitoring time for the telnet connection, carry out the following procedure in the administrator EXEC mode.
xg# configure terminal
xg(config)# telnet-server
xg(config)# terminal timeout vty <0-60>
xg(config)# exit
Telnet connection (enabled by default)
SSH connection (disabled by default)
SNMP manager connection
System log transmission
Time synchronization using an NTP server
Configuration file upload/download
Firmware update
Collection of maintenance information
Command
Command
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Login to the device from the serial terminal. The default
user name is "admin". The default password is "password."
Switch to administrator EXEC mode.
Switch to global configuration mode.
Change the IP address and subnet, and set the default
gateway of the management LAN interface.
(Optional)
Set up DNS servers. Up to 4 DNS servers can be set up.
Priority is assigned to DNS servers in the order they are
defined. To change their order, delete them using the no
command before doing so.
(Optional)
Set the name of the network domain.
(Optional)
Associate a remote host name with an IP address.
This allows referencing a remote IP address with a host
name without relying on a DNS server.
Exit to administrator EXEC mode.
Switch to global configuration mode.
Enable Telnet connection,
(Optional)
If the Telnet session timeout period (in minutes) expires the
telnet connection is terminated.
Exit to administrator EXEC mode.
24/315
Task
Task
Advertisement
Table of Contents
