Kernel (Basic Control: 1000-1999) - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide
Message ID
Severity
S0124
Info
S0125
CRITICAL
S0126
ERROR
A.2.2

kernel (Basic Control: 1000-1999)

Message ID
Severity
S1000
CRITICAL
S1001
CRITICAL
P1100
INFO
P1101
INFO
S1900
CRITICAL
Internal Temperature is high. (%1$ %2$)
Explanation
The temperature is high. The system will be shut down if the temperature rises.
[[Inserted string]]%1$, %2$: Temperature value
Solution
Perform the following checks on the device:
Check that the air vent is not blocked.
Check the temperature of the switch environment is within the limits specified.
Shutdown the system because of high temperature alarm. (%1$ %2$)
Explanation
The system was shut down because of high temperature alarm.
[[Inserted string]]%1$, %2$: Temperature value
Solution
Perform the following checks on the device:
Check that the air vent is not blocked.
Check the temperature of the switch environment is within the limits specified.
If the message is displayed even though the device was properly installed, note the message contents and
contact the sales representative.
AC and DC PSUs are mounted.
Explanation
The device mounts both AC PSU and DC PSU.
Solution
AC PSU and DC PSU should not be mounted simultaneously.
Make sure to mount the same type of PSU.
Abnormal reset occurred (WatchDog Reset: code=%1$)
Explanation
The fault monitor control detected an error and rebooted the device.
[[Inserted string]]%1$: Additional information that indicates the cause of the reset.
Solution
Obtain maintenance information using the
restarting the system then note the message content before contacting the sales representative.
MAC address in EEPROM is invalid.
Explanation
An error occurred in the device that stores the device's MAC addresses.
Solution
Note the message contents and contact the sales representative.
%1$: config: auto-negotiation on, %2$
Explanation
Management LAN auto-negotiation is being performed.
[[Inserted string]]%1$: Name of target network interface
[[Inserted string]]%2$: Displays supported features (speed and duplex).
%1$: status: link %2$
Explanation
The link status of the management LAN changed.
[[Inserted string]]%1$: Name of target network interface
[[Inserted string]]%2$: Displays details of the current link state.
Core dumped %1$
Explanation
A critical firmware error was detected and a process dump was output.
[[Inserted string]]%1$: Process number
Solution
Obtain maintenance information using the
take note of the message content before contacting the sales representative.
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Message/Explanation/Solution
Message/Explanation/Solution
"tftp put-maintenance" or
"tftp put-maintenance" or
283/315
put-maintenance" command after
"scp
put-maintenance" command then
"scp