Spanning-Tree Port-Priority; Spanning-Tree Port-Path-Cost - Fujitsu XG2000 Series User Manual

XG2000 series User's Guide

5.11.7 spanning-tree port-priority

Function
Sets a port priority within the Spanning Tree.
A smaller value has a higher priority.
Use the no form to return to the default setup.
Prompt
xg(config-if)# or xg(config-agg)#
Command syntax
spanning-tree port-priority <0-240>
no spanning-tree port-priority
Parameter
port-priority <0-240>
Specifies a port priority value within the Spanning Tree. Specify a value divisible by 16.
It can be within the range of 0 to 240.
Command type
Configuration command
Default
128
Message
% Priority is not step of 16
Explanation
The priority value specified is not an integer divisible by 16.
Solution
Specify a priority value divisible by 16.
Example
Set the priority of port2 to 160.
xg(config)# interface port 2
xg(config-if)# spanning-tree port-priority 160

5.11.8 spanning-tree port-path-cost

Function
Sets a path cost for each port.
Use the no form to return to the default setup.
Prompt
xg(config-if)# or xg(config-agg)#
Command syntax
spanning-tree port-path-cost <1-200000000>
no spanning-tree port-path-cost
Parameter
port-path-cost <1-200000000>
Sets a path cost for each port. It can be within the range of 1 to 200000000.
The following path cost values are recommended by IEEE802.1D.
Link speed
Command type
Configuration command
Configuration command Default
2 (16bit)
2000 (32bit)
Example
Set the path cost for port 2 to 3:
xg(config)# interface port 2
xg(config-if)# spanning-tree port-path-cost 3
IEEE802.1D (16bit)
Recommended
range
100M bps 10 - 60
1G bps 3 - 10
10G bps 1 - 5
All Rights Reserved, Copyright (C) PFU LIMITED 2009
Recommended Recommended
value
19 20000 - 2000000
4 2000 - 200000
2
166/315
IEEE802.1D (32bit)
Recommended
range value
200000
20000
200 - 20000 2000