Configuring The Device As An Ssh Client - 3Com Switch 4500 26-Port Configuration Manual

326 C 19: SSH T
HAPTER ERMINAL
Configuring the Device
as an SSH Client
S
ERVICES
Open an SSH Connection with Password
1 Click <Open>. The following SSH client interface appears. If the connection is
normal, you will be prompted to enter the username and password, as shown in
Figure 100.
Figure 100 SSH client interface
2 Enter the username and password to create an SSH connection.
3 To log out, enter the quit command.
Table 355 describes the tasks required to configure an SSH client.
Table 355 SSH client configuration
No Configuration Item
1 Set to perform the
first-time authentication
on the SSH server to be
accesseds
2 Specify the public key
of the server
3 Start the SSH client
1 Starting the SSH client
Use this configuration task to enable the connection with the SSH client and the
server, and specify the preferred key exchange algorithm, encryption algorithm
and HMAC algorithm of the client and the server. Perform the following
configuration in system view.
Command
ssh client
first-time enable
ssh client
server-ip assign
rsa-key keyname
ssh2
View Description
System view Optional
System view Required
System view Required