Sending The Information To Control Terminal - 3Com Switch 4500 26-Port Configuration Manual

264 C 15: S
HAPTER YSTEM
Sending the Information
to Control Terminal
M D
AINTENANCE AND EBUGGING
Table 287 Defining information source
Operation
Define information source
Cancel the configuration of
information source
specifies the module name; default represents all the modules; level
modu-name
refers to the severity levels; severity specifies the severity level of information. The
information with the level below it will not be output. channel-number specifies
the channel number and channel-name specifies the channel name.
When defining the information sent to the loghost, channel-number or
channel-name must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When
there is no specific configuration record for a module in the channel, use the
default one.
If you want to view the debugging information of some modules on the switch,
you must select debugging as the information type when configuring information
source, meantime using the debugging command to turn on the debugging
switch of those modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 288 Configuring the output format of time-stamp
Operation
Configure the output format of
the time-stamp
Output time-stamp is disabled
4 Configuring loghost
The configuration on the loghost must be the same with that on the switch. For
related configuration, see the configuration examples in the later part.
To send information to the control terminal, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Command
info-center source { modu-name |
default } channel { channel-number
| channel-name } [ { log | trap |
debug }* { level severity | state
state }* ]
undo info-center source {
modu-name | default } channel {
channel-number | channel-name }
Command
info-center timestamp { log | trap
| debugging } { boot | date | none
}
undo info-center timestamp { log |
trap | debugging }