3Com Switch 4500 26-Port Configuration Manual page 210

208 C 11: 802.1X C
HAPTER ONFIGURATION
Setting the Password Display Mode
Perform the following configurations in System View.
Table 217 Setting the Password Display Mode of Local Users
Operation
Set the password display mode of
local users
Cancel the configuration of
password display mode
means that the password display mode will be the one specified by the user
auto
at the time of configuring the password (see the
for reference), and
the accessing users must be in cipher text.
Setting the Attributes of Local Users
Perform the following configurations in Local User View.
Table 218 Setting/Removing the Attributes Concerned with a Specified User
Operation
Set a password for a specified user
Remove the password set for the
specified user
Set the state of the specified user
Set a priority level for the user
Restore the default priority level
Set a service type for the specified
user
Cancel the service type of the
specified user
Configure the attributes of
lan-access users
Remove the attributes defined for
the lan-access users
Note the following two items when you configure these service types: SSH, Telnet
or Terminal.
When you configure a new service type for a user, the system adds the
■
requested service-type to any existing configuration. For example, if the user
previously had just Telnet access, and SSH was added, the user would now
have access to both Telnet and SSH.
You can set user level when you configure a service type. If you set multiple
■
service types and specify the user levels, then only the last configured user level
is valid. Some of the service types allow a user-privilege level to be entered as
an optional extra parameter. For example Telnet, Terminal & SSH.
Command
local-user password-display-mode {
cipher-force | auto }
undo local-user
password-display-mode
means that the password display mode of all
cipher-force
Command
password { simple | cipher } password
undo password
state { active | block }
level level
undo level
service-type { ftp [ ftp-directory
directory ] | lan-access | { ssh |
telnet | terminal }* }
undo service-type { ftp [ ftp-directory
] | lan-access | { ssh | telnet |
terminal }* [ level level ] }
attribute { ip ip_address | mac
mac_address | idle-cut second |
access-limit max_user_number | vlan
vlanid | location { nas-ip ip_address
port portnum | port portnum } }*
undo attribute { ip | mac | idle-cut |
access-limit | vlan | location }*
command in
password
Table 218