3Com Switch 4500 26-Port Configuration Manual page 151

Table 151 Commands for Controlling ACL Access via SNMP
To
Use ACLs, and Use ACLs when
control users configuring the
accessing switches SNMP community
by SNMP name commands
Use ACLs when
you configure the
SNMP group name
command
The snmp-agent community, snmp-agent group and snmp-agent usm-use
■
commands can use different ACLs.
You can only use number-based basic ACLs for ACL control over network
■
management users.
Configuration Example
Network Requirements Only the SNMP users with the IP address
10.110.100.52 and 10.110.100.46 are allowed to access switches.
ACL Control Configuration
Type This Command
snmp-agent community
{ read | write }
community-name [ [
mib-view view-name ]
| [ acl acl-number ]
]
snmp-agent group { v1
| v2c } group-name [
read-view read-view ]
[ write-view
write-view ] [
notify-view
notify-view ] [ acl
acl-number ]
snmp-agent group v3
group-name [
authentication |
privacy ] [ read-view
read-view ] [
write-view write-view
] [ notify-view
notify-view ] [ acl
acl-number ]
snmp-agent usm-user {
v1 | v2c } user-name
group-name [ acl
acl-number ]
snmp-agent usm-user
v3 user-name
group-name [
authentication-mode {
md5 | sha }
auth-password ] [
privacy-mode des56
priv-password ] [ acl
acl-number ]
149
Description
SNMP community
name is a feature of
SNMP V1 and SNMP
V2 versions. Using
ACLs can filter
network
management system
of SNMP V1 and
SNMP V2 versions
when you configure
the SNMP community
name command.
The SNMP group and
user names are a
feature of SNMP V2
version or later. Using
ACLs can filter the
network
management system
of SNMP V2 version
or later when you
configure the
commands for the
SNMP group and user
names. If you
simultaneously
configure ACL control
function for the two
commands, the
switch will filter the
two attributes for the
network
management user.