Front Panel - Roland R-44 Owner's Manual

Front Panel

fig.panel-2.eps
Display
The display shows information about the R-44's status.
For details, refer to "Display" (p. 18).
Display Button [DISP]
This button switches the contents of the R-44's display.
For details, refer to "Display" (p. 18).
Stop Button [STOP]
This button stops playback or recording. If you press the [STOP] button during playback, the timer
counter displays the time when you pressed the [STOP] button.
Pause Button [PAUSE]
This button pauses playback or recording. During recording, sound is still output even if paused.
Record Button [REC]
Recording will begin immediately when you press the [REC] button. The [REC] button is lit red during
recording. If you hold down the [PAUSE] button and press the [REC] button, the [REC] button will blink
red, and the R-44 enters recording standby mode. Recording will begin when you press the [REC] button
or [PAUSE] button
Input Level Knobs 1–4 [LEVEL]/[SENS]
These knobs adjust the input level from each Combo input jack 1–4
You can adjust sensitivity to 11 levels: +4, -2, -8, -14, -20, -26, -32, -38, -44, -50, and -56 dBu. You can also set
the level from negative infinity to +8 dB, with the central position at 0 dB.
* When using Internal mics
be set from negative infinity to +18 dB. Also, sensitivity for both MIC-L and MIC-R can be adjusted with Input
level knob 1. The level for MIC-L can be adjusted with Input level knob 1, and the level for MIC-R can be
adjusted with Input level knob 2.
Monitor Level Knob [MONITOR (PUSH) SELECT]
This knob adjusts the output volume from the Internal speakers
This knob does not adjust the volume from the Line output jacks
of the Line output jacks, adjust the controls of the external speakers or playback system connected to the
Line output jacks.
You can press the this knob from the main screen to select a channel to monitor.
For details, refer to "Display" (p. 18).
Headphone Jack [PHONES]
You can connect a set of headphones with this jack. Use the Monitor level knob
If you connect headphones, no sound is output from the Internal speakers
.
1 , sensitivity can be set to one of three levels (Low, Mid, or Hi) and the level can
Introducing the R-44
(p. 30).
and the Headphone jack
2
. If you want to adjust the volume
to adjust the volume.
2
.
.
13