Panel Descriptions; Front Panel - Roland Quad-Capture Owner's Manual

Panel Descriptions

Note
Do not connect the QUAD-CAPTURE to the computer until the driver has been installed (p. 14).

Front Panel

1
1. INPUT 1L jack, INPUT 2R jack (Combo input jacks)
These are analog audio input jacks with microphone preamps.
They accommodate both XLR type and phone type plugs,
allowing you to use the type appropriate for the equipment
you're connecting. They also support either balanced or
unbalanced connections.
XLR type:
Phone type:
Switch the [Hi-Z (INPUT 1)] switch (p. 13) or [PHANTOM] switch (p. 13)
depending on the equipment that is connected.
* The INPUT 2R jack is fixed at low impedance. If you connect a guitar or bass to the INPUT 2R jack
directly, audio input volume will be insufficient.
* This instrument is equipped with
balanced (XLR/TRS) type jacks. Wiring
diagrams for these jacks are shown on
the right. Make connections after first
checking the wiring diagrams of other
equipment you intend to connect.
2.
[SENS 1L] knob, [SENS 2R] knob (Input sensitivity knobs)
Adjust the volume of the audio signal that is input via the INPUT 1L jack or INPUT 2R jack.
3. Input level indicator
Indicates the input level of the audio signal.
Indicates the value of the input sensitivity that is currently set if the AUTO-SENS setting (p. 26) is set to
on and an audio signal is not input for a certain amount of time.
10
1 3
2
-60– -6 dBu
-50–+4 dBu
4 6 7
3
5
2 8
1: GND
2: HOT
3: COLD
9
10
XLR type
Phone type
TRS phone
(unbalanced)
type
(balanced)
GND (SLEEVE)
HOT (TIP)
COLD (RING)