Display Setup - Roland R-44 Owner's Manual

3 Speaker
Parameter
Speaker
Switch

4 Display Setup

Parameter
Bright
Display
Timer
Button Light
Illumination
5 System Setup
Parameter
Battery
Type
Ext-Power
Output Sel
Sync Mode
Project File
Value Function
This switches the internal speakers on/off.
* Even if this is set to on, no sound is played from the internal speakers during
OFF, ON
recording standby or recording. The speakers also remain silent while headphones are
being used.
Value Function
This adjusts the display's contrast. Higher values emphasize the white areas of
1–5–10
the display.
Sets the amount of time until the display becomes dark when no operations have
OFF, 2 sec,
been performed on the R-44.
5 sec, 10 sec,
If you are operating the R-44 on battery power, use this setting to conserve
20 sec
battery life.
Auto, Sets the button brightness. When set to Auto, the button light darkens linked to
Dim, Bright the set time of the Display Timer.
All buttons are dimly lit. Button positions are easily verified even in dark
OFF, ON
locations.
Value Function
Sets the type of batteries you are using.
Choose the Alkaline setting if you are using alkaline batteries or Ni-MH if you
Alkaline,
are using nickel metal-hydride batteries.
Ni-MH
* If you choose a setting that does not match the type of batteries that are actually
installed, the remaining battery power indication will be incorrect.
Adaptor,
Sets the final voltage when using an external power source. The "Battery Low!"
9.0/9.5/
message is displayed when the voltage of the external power source drops
10.0/10.5/
below the set voltage and if the voltage drops further, the power automatically
11.0/11.5/
turns off.
12.0V
Sets the sound output type (p. 18).
4-indiv
The sound from each channel from LINE OUT is output without modification.
monitor Sound is output according to the output assignments
Sets the sync signal mode (p. 73).
Master
These settings are for the transmission side.
Slave These settings are for the receiving side.
This specifies the desired format of the project files created during recording or
editing. If you select WAV, a conventional WAV file will be created. If you
WAV, BWF
select BWF, a BWF file containing information about the recording time and
recording device (EDIROL R-44) will be created.
System Setup
69