Measuring At One Listening Position (Single Measure) - Yamaha RX-A3020 Owner's Manual

1 2 3 4 5 6 7 8 9
Automatic speaker setup
SOURCE SOURCE RECEIVER RECEIVER
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 4 4
PHONO PHONO MULTI MULTI L L USB USB NET NET
TUNER TUNER [ A ] [ A ] [ B ] [ B ] [ C ] [ C ]
SCENE
1 2 3 4
VOLUME
PROGRAM MUTE
TOP MENU POP-UP/MENU
ON SCREEN OPTION
Cursor keys
ENTER
ENTER
RETURN
RETURN DISPLAY
MODE
LIVE
CLASSICAL ENTERTAIN
CLUB
PRESET
MOVIE STEREO STRAIGHT
TV
PURE
INPUT
DIRECT
TV VOL TV CH
MUTE
❑ Angle
(RX-A3020 only)
Enables/disables the angle measurement.
Settings
Enables the angle measurement. The unit will measure
angle of each speaker at the listening position and
Yes
correct the speaker parameters so that CINEMA DSP
can create more effective sound fields.
No (default) Disables the angle measurement.
Measuring at one listening position
(single measure)
When "Multi Position" is set to "No", follow the procedure below for
measurement.
• Do not stand between the speakers and the YPAO microphone during the
measurement process (about 5 minutes).
• Move to the corner of the room or leave the room.
• If any error message (such as E-1) or warning message (such as W-1) appears,
see "Error messages" (p.58) or "Warning messages" (p.59).
1
To start the measurement, use the cursor keys to
select "Measure" and press ENTER.
The measurement will start in 10 seconds. Press ENTER
again to start the measurement immediately.
• To cancel the measurement temporarily, press RETURN.
The following screen appears on the TV when the
measurement finishes.
(RX-A2020)
(RX-A3020 [when angle measurement is disabled])
Proceed to Step 3.
PREPARATIONS ➤ Optimizing the speaker settings automatically (YPAO)
52
En