Yamaha RX-A3020 Owner's Manual page 21

1 2 3 4 5 6 7 8 9
Speaker connections
■
Setting the speaker impedance
Under its default settings, the unit is configured for 8-ohm speakers. When connecting
6-ohm speakers, set the speaker impedance to "6 Ω MIN". In this case, you can also
use 4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the power cable to an AC wall
outlet.
2
While holding down STRAIGHT on the front panel, press
MAIN ZONE z.
MAIN ZONE z
STRAIGHT
3
Check that "SPEAKER IMP." is displayed on the front display.
SP IMP. - SPEAKER IMP.
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
8 MIN
2 3 4
IN OUT 1 OUT 2
ENHANCER SLEEP
HD 3
4
Press STRAIGHT to select "6 Ω MIN".
5
Press MAIN ZONE z to set the unit to standby mode and remove the
power cable from the AC wall outlet.
You are now ready to connect the speakers.
MUTE VOLUME
ADAPTIVE DRC
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
PREPARATIONS ➤ Connecting speakers
21
En