Error Indications On The Front Display - Yamaha RX-A3020 Owner's Manual

Error indications on the front display

Message Cause
Access denied Access to the PC is denied.
The unit cannot access the USB device.
The unit cannot access the iPod.
Access error The connected iPod is not supported by the unit.
There is a problem with the signal path from the network to the unit.
Check SP Wires The speaker cables short circuit.
Internal Error An internal error has occurred.
No content There are no playable files in the selected folder.
The unit cannot detect the USB device.
No device
The unit cannot detect the iPod.
Please wait The unit is preparing for connecting to the network.
The remote control IDs of the unit and the remote control are not
RemID Mismatch
identical.
The unit cannot be operated from remote control because the
Remote Off
remote control sensor on the main unit is turned off.
The unit cannot play back the songs stored on the USB device for
some reasons.
The unit cannot play back the songs stored on the iPod for some
reason.
Unable to play
The unit cannot play back the songs stored on the PC for some
reason.
USB Overloaded An overcurrent is flowing through the USB device.
Remedy
Configure the sharing settings and select the unit as a device to which music contents are shared
(p.83).
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Turn off the iPod and turn it on again.
Use an iPod supported by the unit (p.76).
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub) (p.45).
Twist the bare wires of the cables firmly and connect to the unit and speakers properly.
Contact the nearest authorized Yamaha dealer or service center.
Select a folder that contains files supported by the unit.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Turn off the iPod and then turn it on again.
Wait until the message disappears. If the message stays more than 3 minutes, turn off the unit and turn
it on again.
Change the remote control ID of the unit or the remote control (p.133).
Use the controls on the front panel. To use the remote control, set "REMOTE SENSOR" in the
"ADVANCED SETUP" menu to "ON" (p.133).
Check the song data. If it cannot be played on another device, the song data may be defective.
Check the song data. If it cannot be played on the iPod itself, the song data or storage area may be
defective.
Check if the format of files you are trying to play is supported by the unit. For information about the
formats supported by the unit, see "Playing back music stored on media servers (PCs/NAS)" (p.83). If
the unit supports the file format, but still cannot play back any files, the network may be overloaded with
heavy traffic.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
APPENDIX ➤ Error indications on the front display
152
En