Error Indications On The Front Display - Yamaha RX-V485 Owner's Manual

Error indications on the front display

Error indications on the front display
Refer to the following table when the error message is indicated on the front display.
Message Cause
Access denied Access to the media servers (PCs/NAS) is denied.
The unit cannot access the USB device.
Access error
There is a problem with the signal path from the network to the unit.
Check SP Wires The speaker cables are short circuited.
An internal error has occurred.
Internal Error
No content There are no playable files in the selected folder.
No device The unit cannot detect the USB device.
The network cable is not connected.
Not connected
The wireless router (access point) is not found.
The unit is preparing for connecting to the network.
Please wait
The remote control IDs of the unit and the remote control are not
RemID Mismatch
identical.
The unit cannot play back the songs stored on the iPhone for some
reason.
Unable to play
The unit cannot play back the songs stored on the media servers
(PCs/NAS) for some reason.
USB Overloaded An overcurrent is flowing through the USB device.
Version error Firmware update failed.
Remedy
Configure the sharing settings and select the unit as a device to which music contents are shared. For
details, see the following:
• "Media sharing setup on media servers (PCs/NAS)" (p.68)
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Make sure your router and modem are turned on, and check the connection between the unit and your
router (or hub). For details, see the following:
• "Connecting a network cable (wired connection)" (p.29)
• "Preparing wireless antennas (wireless connection)" (p.30)
Twist the bare wires of the cables firmly and connect to the unit and speakers properly. For details, see
the following:
• "Connecting the speaker" (p.18)
Contact the nearest authorized Yamaha dealer or service center.
Select a folder that contains files supported by the unit.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Connect the network cable properly.
Make sure the wireless router (access point) is turned on.
Wait until the message disappears. If the message stays more than 3 minutes, turn off the unit and turn
it on again.
Change the remote control ID of the unit or the remote control. For details, see the following:
• "Selecting the remote control ID (REMOTE ID)" (p.116)
Check the song data. If it cannot be played on the iPhone itself, the song data or storage area may be
defective.
Ensure that the files are types that the unit is able to play back. If the unit supports the file format, but
still cannot play back any files, the network may be overloaded with heavy traffic. For information about
the formats supported by the unit, see the following:
• "Supported file formats" (p.143)
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Update the firmware again. For details, see the following:
• "Updating the firmware (UPDATE)" (p.118)
• "Updating the unit's firmware via the network" (p.133)
130
En