Table of Contents
Advertisement
Error indications on the front display
Message
Access denied
Access to the PC is denied.
The unit cannot access the USB device.
Access error
There is a problem with the signal path from the network to the unit.
Check SP Wires
The speaker cables short circuit.
Internal Error
An internal error has occurred.
No content
There are no playable files in the selected folder.
No device
The unit cannot detect the USB device.
Please wait
The unit is preparing for connecting to the network.
The remote control IDs of the unit and the remote control are not
RemID Mismatch
identical.
Unable to play
The unit cannot play back the songs stored on the PC for some reason.
USB Overloaded
An overcurrent is flowing through the USB device.
Version error
Firmware update is failed.
Update failed.
Firmware update is failed.
Cause
Configure the sharing settings and select the unit as a device to which music contents are shared (p.83).
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Make sure your router and modem are turned on.
Check the connection between the unit and your router (or hub) (p.37).
Twist the bare wires of the cables firmly and connect to the unit and speakers properly.
Contact the nearest authorized Yamaha dealer or service center.
Select a folder that contains files supported by the unit.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Wait until the message disappears. If the message stays more than 3 minutes, turn off the unit and turn it on
again.
Change the remote control ID of the unit or the remote control (p.136).
Check if the format of files you are trying to play is supported by the unit. For information about the formats
supported by the unit, see "Playing back music stored on media servers (PCs/NAS)" (p.83). If the unit supports
the file format, but still cannot play back any files, the network may be overloaded with heavy traffic.
Turn off the unit and reconnect your USB device. If the problem persists, try another USB device.
Update the firmware again.
Press STRAIGHT and select a firmware updating method, then press INFO to update the firmware again.
149
En
Remedy
Advertisement
Table of Contents
