Configure Advanced Wan Options And Other Tasks - NETGEAR ProSafe FVS318N Reference Manual

For SIIT to function, the routing mode needs to be IPv4 / IPv6. NETGEAR's implementation of
SIIT lets you enter a single IPv4 address on the SIIT screen. This IPv4 address is then used
in the IPv4-translated address for IPv6 devices to enable communication between IPv4-only
devices on the wireless VPN firewall's LAN and IPv6-only devices on the WAN.

To configure SIIT:
1. Select Network Configuration > SIIT. The SIIT screen displays:
Figure 28.
2. Select the Enable SIIT check box.
3. In the SIIT Address fields, enter the IPv4 address that should be used in the IPv4-translated
address for IPv6 devices.
4. Click Apply to save your changes.

Configure Advanced WAN Options and Other Tasks

The advanced options include configuring the maximum transmission unit (MTU) size, port
speed, and wireless VPN firewall's MAC address, and setting a rate limit on the traffic that is
being forwarded by the wireless VPN firewall.
Note: Although you can access the Broadband Advanced Options screen
only through the Broadband ISP Settings (IPv4) screen, the
advanced options apply to both IPv4 and IPv6 WAN connections.

To configure advanced WAN options:
1. Select Network Configuration > WAN Settings > Broadband ISP Settings. The
Broadband ISP Settings screen displays the IPv4 settings (see
2. Click the Advanced option arrow in the upper right of the screen. The Broadband Advanced
Options screen displays:
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
IPv4 and IPv6 Internet and Broadband Settings
50
Figure 10 on page 29).