NETGEAR ProSafe FVS318N Reference Manual page 216

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Figure 129.
3. Specify the settings that are explained in the following table.
Table 49. VPN client IPSec configuration settings
Setting
VPN Client address
Address Type
Remote LAN address Enter 192.168.1.0 as the remote IP address (that is, LAN network address) of the
Subnet mask
ESP
Virtual Private Networking Using IPSec and L2TP Connections
Description
Either enter 0.0.0.0 as the IP address, or enter a virtual IP address that is used by
the VPN client in the wireless VPN firewall's LAN; the computer (for which the VPN
client opened a tunnel) appears in the LAN with this IP address.
Select Subnet address from the drop-down list. This selection defines which
addresses the VPN client can communicate with after the VPN tunnel is
established.
gateway that opens the VPN tunnel.
Enter 255.255.255.0 as the remote subnet mask of the gateway that opens the VPN
tunnel.
Encryption Select 3DES as the encryption algorithm from the drop-down list.
Authentication Select SHA-1 as the authentication algorithm from the drop-down
list.
Mode Select Tunnel as the encapsulation mode from the drop-down list.
216