NETGEAR ProSafe FVS318N Reference Manual page 149

2. Enter the settings as explained in
Service, Action, and Log drop-down lists, you need to make selections from the following
drop-down lists:
• DMZ Users
• WAN Users
Unless your selection from the Action drop-down list is BLOCK always, you also need to
make selections from the following drop-down lists:
• Select Schedule
• QoS Priority
• NAT IP (This drop-down list is available only when the WAN mode is NAT. If you
select Single Address, the IP address specified should fall under the WAN subnet.)
3. Click Apply. The new rule is now added to the Outbound Services table. The rule is
automatically enabled.
IPv6 DMZ WAN Outbound Service Rules

To create a new IPv6 DMZ WAN outbound rule:
1. In the upper right of the DMZ WAN Rules screen, select the IPv6 radio button. The screen
displays the IPv6 settings (see
2. Click the Add table button under the Outbound Services table. The Add DMZ WAN
Outbound Service screen for IPv6 displays:
Figure 72.
ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Table 33
Figure 70
Firewall Protection
on page 131. In addition to selections from the
on page 147).
149